It is necessary to pay attention to maintenance during operation, and daily attention to maintenance and maintenance can increase the service life of the equipment, save costs and create greater benefits.

Let me introduce to you the precautions for using laser cleaning machine.

Today, when environmental protection is advocated, laser cleaning machines have the characteristics of non-contact, no thermal effect, and no mechanical force on the surface of the cleaned object. It is widely used in industry, so what should be paid attention to when using laser cleaning machine?

1.Follow the switching sequence of the machine: when starting up, first turn on the water pump (water cooler), then turn on the power switch, and then turn on the laser switch. When shutting down, first turn off the laser switch, then turn off the power switch, and then turn off the water pump (water cooler).

2.Clean the chiller of the laser machine every half a month, drain the internal dirty water, and then fill up with new pure water (dirty water will affect the light output effect).

3.It is required to clean regularly and quantitatively every day, remove the sundries on the table, limiter and guide rail, and spray lubricating oil on the guide rail.

 4.The reflector and focusing lens should be scrubbed with a special cleaning solution every 6-8 hours. When scrubbing, use a cotton swab or cotton swab dipped in the cleaning solution to scrub counterclockwise from the center of the focusing lens to the edge. At the same time, care should be taken to prevent scratches lens.

5.Cleaning method of exhaust fan and smoke pipe: When there is a lot of smoke and dust during processing, it is necessary to clean the fan. Remove the outer cover of the fan, scrape off the dust on the fan blades and the air channel with a thin wood chip, and then blow it with a high-pressure gun. Clean dust, the method of cleaning the smoke pipe is the same as the method of cleaning the water of the exhaust fan.

During the operation of laser cleaning machine equipment, a large amount of corrosive dust and smoke will be generated during the processing of the workpiece, and these smoke and dust will be deposited on the surface of guide rails and linear shafts for a long time, which will have a great impact on the processing accuracy of the equipment. , and will form corrosion spots on the surface of the linear axis of the guide rail, shortening the service life of the equipment. In order to make the machine work normally and stably, and ensure the processing quality of the product, the daily maintenance of the guide rail and the linear axis must be carefully done.